BCDs
Computers
Fins
Gauges
Masks
Mask and Fin Packages
Manifolds & Valves
Regulators & Octopuses
Scuba Packages
Scuba Snorkels
Tanks
Weights & Belts
Wings
![]()
Dive Boots
Dive Gloves
Drysuits
Hoods
Skins & Rashguards
Vests
Wetsuits
![]()
Bags
Books & Media
Clips & Attachments
Dive Slates
Dry Cases
Fin Straps
Flags & Buoys
Hose Keepers
Hoses
Inflator Hoses
Inflators
Knife Straps
Knives
Lights
Mask Straps
Mouthpieces
Photography
Safety Reels
Snorkel Keepers
Tank Caps
Tank Straps
Tools
Watches
![]()
Fins
Kid's Masks
Kid's Snorkeling Gear
Masks
Snorkeling Bags
Snorkels
Vests
Home > Learning Center > Women's Wetsuits
Click here to see our selection
of Women's Wetsuits.
![]()
Women’s wetsuits are not fundamentally different from men’s suits, but they do need to be structurally different. The basic composition of a women’s suit is identical to a men’s suit. Both are made primarily of neoprene.
Neoprene was actually the first synthetically mass produced rubber compound. It contains small pockets of gas within rubber foam. The gas used for wetsuit creation is nitrogen. The gas provides insulating properties, while the foam gives elasticity to the material that would otherwise be lacking.
Both properties are essential for women’s wetsuits, as well as men’s to function properly. A wetsuit needs to be form fitting, to prevent the exchange of water from inside to outside from occurring. This is important because if water is continuously exchanged, your body must constantly heat new, colder water back up to body heat. Your body’s heat levels are much higher than the warmest ocean water, which causes the water to leech heat off of you. The wetsuit counters this by trapping a small layer of water next to your skin. Once this thin layer of water is heated t body temperature, it, in conjunction with the neoprene, forms a thermally protective barrier against the outside water temperature.
This barrier is only effective when the layer of water is too small to sustain currents, which could cause leakage. And that is why, while common in principle, women’s wetsuits are structurally different than men’s. A woman is typically larger in the hips, smaller in the shoulders, and larger in bust than a man of similar height. This means that two areas of a wetsuit could potentially fail, while another sported large pockets of useless water within the suit.
Instead, women’s wetsuits can be manufactured to their specific body, ensuring a good fit. A good fit that is snug without restricting movement is the key to a wetsuit that is comfortable and effective. Without both features, one aspect or another of the wetsuit’s design will be going to waste. This is especially important to remember if you are going to go on a tourist dive and will be working with a rental suit. The selection is often limited in these locations, because the cost of maintaining hundreds of wetsuits, only a few of which are used, can be a deal breaker for a business. You should ensure that you get as good a fit as possible within their selection.
One thing that has made all wetsuits, including women’s wetsuits more comfortable and easier to wear is the addition of nylon sheeting to the neoprene. Neoprene itself is prone to sticking to wet skin, and it can tear when subjected to large amounts of lateral stress. So it was an extremely delicate process to don and remove a wetsuit. Nylon backing allowed a wetsuit to slide on and off, and it also added strength to the suit itself. Soon, nylon was placed on each side of the suits, to better protect both the inside and outside of the neoprene.